LiftMaster CB11 control panel and enclosure for electric gates, designed for 230v/50Hz motors, compatible with LiftMaster, Chamberlain and MotorLift branded products.

Watertight enclosure/box supplied as standard, but does not include a radio receiver board, this must be purchased separately.

Features

• Separate power/force adjustment for each wing
• Adjustable wing delay option for overlapping wings
• Dip-switches for general program selection
• Soft start and stop
• Various radio modules options (433MHz / 27MHz / 315MHz)
• Memory for 80 remote controls
• Pedestrian opening function
• Adjustable automatic closing
• Connection for 2 electric locks
• Connection for safety infrared photocells aka light barriers (protector system model 770E)
• Watertight enclosure/box supplied as standard
• Conforms with CE, EN12453 & EN13241-1.
• TÜV-Tested.

Please Note: The CB11 control board is NOT supplied with the LiftMaster 41A5456B radio receiver card as standard. However, you can add this radio receiver card to your order separately if required.

Installation

The CB11 control board was designed for installation in a special, waterproof box (203391). Before fitting, measure the required distances and determine the correct holes. Use a screwdriver to force the plastic out of the holes. Insert threaded cable connections with strain relief, hold the box against the surface on which it is to be mounted.

Insert screws through the mounting holes in the rear panel and tighten. The motor control unit is a highly modern electronic unit controlled by a microprocessor. It has all wiring facilities and functions required for safe operation.

Moisture and water will destroy the control board. Make sure under all circumstances that water, moisture or storage moisture cannot penetrate the control board. Make sure that all openings and cable entries are sealed watertight.

The control box with the motor control unit is mounted with the cable entries facing down. It must not be permanently exposed to direct sunlight. The electronics can be used for the precise adjustment of the push-pull torque. The gate can be held by hand if the fitting/setting is correct.

During operation, the gate can be stopped at all times via remote control, push-button or key- operated switch. The gate wing requires a firm stop for the “OPEN” and “CLOSED” positions, because the gate drives have no limit switch.

Alternate Model Numbers

This control board can also be identified by the following alternative product codes:

• 041ASWG-0370

Help Resources

LiftMaster CB11 Control Panel Manual

LiftMaster CB11 Control Panel Wiring Diagrams

Installation Video

Setting up a CB11 PCB for an automated 2 leaf swing gate installation.